Betekenis van:
edge in

to edge in
Werkwoord
    • push one's way into (a space)

    Synoniemen

    Hyperoniemen

    Werkwoord


    Voorbeeldzinnen

    1. platform edge, quoted in 4.2.20.
    2. Measured in a straight line from the front edge to the back edge of the shell.
    3. For the section of bonnet leading edge to be tested the bonnet leading edge height and the bumper lead shall be determined as defined in Part I.
    4. Where: ΔF is the frequency offset from the relevant block edge (in MHz).
    5. Euro banknotes with part(s) missing, along at least one edge (in contrast to holes)
    6. In width: that edge of the apparent surface in the direction of the reference axis which is farthest from the vehicle's median longitudinal plane shall be not more than 400 mm from the extreme outer edge of the vehicle.
    7. CPA 23.12.11: Glass in sheets, bent, edge-worked, engraved, drilled, enamelled or otherwise worked, but not framed or mounted
    8. Euro banknote with a part/parts missing along at least one edge (in contrast to holes), e.g. a missing corner
    9. Cut a 25 mm slit in the film, starting 50 mm from the edge of the drum.
    10. the outer edge of the apparent surface of at least one lighting unit on each side of the vehicle shall not be more than 400 mm from the extreme outer edge of the vehicle (A in the figure); and,
    11. ‘Third of the bonnet leading edge’ means the geometric trace between the corner reference points, measured with a flexible tape following the outer contour of the leading edge, divided in three equal parts;
    12. If necessary, the ignition source shall be removed from the edge of the sample after approximately two seconds, in order to clearly observe if ignition has occurred.
    13. The point of impact is that part of the protective structure likely to hit the ground first in a rearward overturning accident, normally the upper edge.
    14. This position depends on the position of the edge of the platform, which is specified in clauses 4.2.20.4 and 4.2.20.5 of the Infrastructure TSI 2006.
    15. the thickness of backfat (including rind) in millimetres, measured at the fore edge of the pubic bone, at 11 cm off the midline of the carcase.